Table of Contents
Advertisement
User Manual for the NETGEAR 54 Mbps Wireless PC Card WG511 v2
Removing the WG511 v2 Software
You can use the Resource CD to remove the wireless adapter software.
1. Insert the Resource CD in the computer where
you installed the software. The main page
opens.
2. Click the Install Software button. If the WG511
v2 software has been installed, the Smart
Wizard detects it.
3. Follow the steps of the Smart Wizard to remove
the software.
4. After the software has been removed the
following dialog box appears:
5. Take the WG511 v2 out of its slot and click OK.
Upgrading the WG511 v2 Software
Upgrades may be available at the NETGEAR Web site. To install an upgrade, follow these steps.
1. Write down the settings for any profiles that you want to save. They will not be retained.
2. Download the upgrade from the NETGEAR Web site Support page.
3. Remove the WG511 v2 software from your laptop computer.
You can use the NETGEAR Resource CD as described in the previous section to do this, or
you can use the Windows Control Panel "Add or Remove Programs" feature.
4. Remove the WG511 v2 adapter from your laptop computer, and if prompted restart your
laptop computer.
5. Run the installer that you downloaded (the file ends in .exe).
6. Follow the installer instructions, and if prompted, then restart your laptop computer.
2-10
June 2005
Basic Setup
Advertisement
Table of Contents
