Wireless-G Exterior Access Point
6. Make sure that you properly ground the Access Point.
7. Line up the Access Point's wall-mount slots with the two screws on the wall. Then, slide the Access
Point down so that the screws fit snugly in the slots.
8. Attach a screw (not included) in each of the two holes on the top of the mounting plate so that the Access
Point is securely mounted to the wall.
9. Connect the other end of the Ethernet network cable to a switch, router, or other device that supports
Power over Ethernet. The Access Point will then be connected to your wired network.
Now that the hardware installation is complete, proceed to "Chapter 5: Setting Up the Wireless-G Exterior
Access Point," for directions on how to configure the Access Point.
Chapter 4: Connecting the Wireless-G Exterior Access Point
Hardware Installation
Figure 4-2: Attach the Mounting Plate
Figure 4-3: Ground the Access Point
13