Chapter 6: Configuring The Wireless-G Exterior Access Point; The Setup Tab; Figure 6-1: Setup - Static Ip Address - Linksys WAP54GPE - Wireless-G Exterior Access Point User Manual

Wireless-G Exterior Access Point
Chapter 6: Configuring the Wireless-G Exterior Access
Point
This chapter is a detailed reference guide for the Web-based Utility. You do not need the Utility to start using
your Access Point. The Access Point has been designed to be functional right out of the box with the default
settings. However, if you'd like to change your settings, you can use the Utility.

The Setup Tab

The first screen that appears is the Setup screen. This allows you to change the Access Point's general
settings.
Setup
Enter names for the Access Point. The host name can be used to access the Web Utility through the network
if DNS has been set up. The device name is for the benefit of identifying your Access Point after you log in.
Host Name. The host name assigned to the Access Point. This host name will be published to DNS server if
the Access Point is configured to acquire the IP address through DHCP. In that case, it is recommended to
follow the company policy on the host name assignment. The default name is Linksys.
Device Name. You may assign any device name to the Access Point. This name is only used by the Access
Point administrator for identification purposes. Unique, memorable names are helpful, especially if you are
employing multiple access points on the same network. The default name is WAP54GPE.
Network Setup
The selections under this heading allow you to configure the Access Point's IP address setting(s).
IP Settings
Select Static IP Address (default) if you want to assign a static or fixed IP address to the Access Point. Then
complete the following:
• IP Address. The IP address must be unique to your network. The default IP address is 192.168.1.245.

Chapter 6: Configuring the Wireless-G Exterior Access Point

The Setup Tab

Figure 6-1: Setup - Static IP Address

17