Table of Contents
Advertisement
MODE SENSE
7.8.3.
Device Configuration Page 10h
The drive supports the Device Configuration Page which has the following format:
Bit
7
Byte
0
PS (0)
1
2
Reserved
3
4
5
6
(MSB)
7
8
DBR (0)
9
10
EOD Defined (000b)
11
(MSB)
12
13
14
15
CAP: The Change Active Partition bit, when set to one, indicates that the partition is changed to the one specified
by the Active Partition Field. This is a feature supported by the drive and is discussed below.
CAF: The Change Active Format bit, set to one, indicates that the active format is to be changed to that set in the
Active Format Field.
Active Format: This field is used to enable AIT format options and is described below:
4
Disable RAW
Disable RAW: This bit is used to enable or disable the use of Read-After-Write error detection. If this bit is NOT
set, RAW is enabled. This is the drive's default configuration.
3rd ECC: This bit is used to enable or disable the use of Third Level Error Correction. If this bit is set, 3rd ECC is
enabled. This is the drive's default configuration.
Active Partition: Indicates the current partition number in use on the medium.
Setting this field to a non-existing partition will be rejected by the drive with a CHECK CONDITION status and the
ILLEGAL REQUEST sense key set.
Write Buffer Full Ratio and Read Buffer Empty Ratio: These fields are not supported by the drive. Setting these
fields to anything other than ZERO will cause the drive to return a CHECK CONDITION status and an ILLEGAL
REQUEST sense key.
The drive implements an algorithm which automatically adjusts these ratios so as to maximize streaming to the
Host.
Write Delay Time: This field indicates the maximum time, in 100 millisecond increments, that the drive shall wait
with a partially full buffer before forcing the data to tape. The drive defaults to a 10 second delay since the last bus
activity before the data is flushed from the buffer to the tape. If Write Delay Time is set to ZERO the drive will wait
indefinitely for the data group to be filled.
DBR: This field is not supported and should be always set to ZERO.
SONY AIT-2 Turbo drive SDX-560V series Ver.1.0
Table 7-36: MODE PAGE Device Configuration (10h)
6
5
Reserved
CAP
CAF
Write Buffer Full Ratio (00h)
Read Buffer Empty Ratio (00h)
BIS (1)
RSmk
AVC (0)
EEG (1)
Buffer Size at Early Warning (00 00 00h)
Select Data Compression Algorithm
3
3
ECC
rd
7. ATAPI Packet Command Specification
4
3
2
Page Code (10h)
Page Length (0Eh)
Active Format
Active Partition
Write Delay Time
SOCF (00b)
Gap Size (00h)
SEW
Reserved
2
1
Reserved
1
0
(LSB)
RBO (0)
REW
Reserved
(LSB)
0
7-29
Advertisement
Table of Contents
