NETGEAR DG834Gv4 - 54 Mbps Wireless ADSL Firewall Modem Reference Manual page 109

6. Click Done on the Summary screen (see
procedure. The VPN Policies screen displays, showing that the new tunnel is enabled.
Figure 6-26
Note: See
information about how to enable the IKE keepalive capability on an existing
VPN tunnel.
7. Repeat these steps for the DG834G v4 on LAN B, and pay special attention to using the
following network settings:
• WAN IP of the remote VPN gateway (for example, 14.15.16.17)
• LAN IP settings of the remote VPN gateway:
– IP Address (for example, 192.168.0.1)
– Subnet Mask (for example, 255.255.255.0)
– Preshared Key (for example, 12345678)
8. Use the VPN Status screen to activate the VPN tunnel by performing the following steps:
Note: The VPN Status screen is only one of three ways to active a VPN tunnel. See
"Activating a VPN Tunnel" on page 6-25
Virtual Private Networking
ADSL2+ Modem Wireless Router DG834G Reference Manual
"Using Auto Policy to Configure VPN Tunnels" on page 6-32
v2.0, September 2007
Figure 6-24) to complete the configuration
for information about the other ways.
for
6-23