NETGEAR DG834Gv3 - 54 Mbps Wireless ADSL Firewall Modem Reference Manual page 135

Remote LAN. This identifies which PCs on the remote LAN are covered by this policy. For each
selection, data must be provided as follows:
• Single PC - no Subnet
endpoint. If this option is selected, no additional data is required. The typical application is a
PC running the VPN client at the remote end.
—
• Single address
address on the remote LAN. Typically, this setting is used when you wish to access a server on
the remote LAN.
—
• Range address
finish IP address in the "Finish IP address" field. This must be an address range used on the
remote LAN.
—
• Subnet address
network mask in the "Subnet Mask" field.
The remote VPN endpoint must have these IP addresses entered as its "Local" addresses.
IKE. Direction/Type —
traffic. Select the desired option.
• Responder only—incoming connections are allowed, but outgoing connections will be
blocked.
• Initiator and Responder
—
Exchange Mode ensure the remote VPN endpoint is set to use "Main Mode".
Diffie-Hellman (DH) Group
DH Group setting determines the number of bit size used in the exchange. This value must match
the value used on the remote VPN Gateway.
Local Identity Type—select the desired option to match the "Remote Identity Type" setting on the
remote VPN endpoint.
• WAN IP Address
• Fully Qualified Domain Name
• Fully Qualified User Name
Local Identity Data—enter the data for the selection above. (If WAN IP Address is selected, no
input is required.)
Virtual Private Networking
Reference Manual for the ADSL Modem Wireless Router DG834G
—
select this option if there is no LAN (only a single PC) at the remote
Enter an IP address in the "Single/Start IP address" field. This must be an
enter the starting IP address in the "Single/Start IP address" field, and the
enter an IP address in the "Single/Start IP address" field, and the desired
this setting is used when determining if the IKE policy matches the current
—
both incoming and outgoing connections are allowed.
—
the Diffie-Hellman algorithm is used when exchanging keys. The
—
your Internet IP address.
—
your domain name.
—
your name, E-mail address, or other ID.
v1.0, January 2006
7-41