System Configuration - NEC POWERMATE VE - SERVICE MANUAL 08-1996 Service Manual

Use the CD-ROM reader to load and start programs from a CD or to play audio CDs. The
CD-ROM reader has the following controls and indicators:
T
jack for connecting headphones with a stereo mini-jack plug
T
volume control for adjusting the headphone volume
T
busy lamp that lights during read operations
T
open/close button for opening or closing the CD tray when the power is on. When
playing a CD, press the open/close button to stop the CD.
T
emergency eject hole in the front panel for manually opening the CD tray if power
is lost. Insert a jewelers screwdriver into the hole. Turn the screw
counterclockwise to open the tray and clockwise to close the tray.
CD Tray
Headphone
Jack
Figure 2-5 Typical CD-ROM Reader Controls and Indicators
To load a disc in the CD-ROM reader, follow these steps.
Press the open/close button. The CD tray opens.
1.
2. Put the CD, printed side up, into the tray.
3. Press the open/close button again and the tray closes.
To remove the disc, press the open/close button. The tray opens, allowing
4.
removal of the disc.

SYSTEM CONFIGURATION

This section describes the Setup utility program that allows the system configuration
information to be viewed and changed.
CD Busy
Lamp
Emergency
Eject Hole
Volume Control
Open/Close
Knob
Button
Setup and Operation 2-5