Expansion Board Removal - NEC POWERMATE VE - SERVICE MANUAL 08-1996 Service Manual

2. Remove the two cover screws shown in Figure 5-1.
Slide the system unit cover toward the front about one inch.
3.
Lift the system unit cover up and off (see Figure 5-2).
4.

Expansion Board Removal

Remove any installed expansion board(s) using Figure 5-3 through Figure 5-4 and the fol-
lowing steps.
Remove the system unit cover as previously described.
1.
2. Disconnect any cables leading from the expansion board(s).
3. Remove the screw from the expansion slot bracket (see Figure 5-3).
Figure 5-1 System Unit Cover Screws
Figure 5-2 Removing the System Unit Cover
System Unit Repair
Screws
5-3