Lubrication - Grizzly G3616 Owner's Manual

Lubrication

Power Feed
The power feed uses SAE 40 oil.
Ball Fittings
Ball fittings, shown in Figures 51–57, are respon-
sible for the majority of the machine lubrication.
To lubricate ball fittings, depress the ball with the
tip of the oil can nozzle and squirt a little oil inside
the fitting. Make sure to clean the outside of the
ball fitting before and after each use to keep out
contaminants.
For ball fitting lubrication points, use a manual
oiler (oil can) filled with ISO 68 or SAE 20W non-
detergent oil or similar lubricant.
Lubricate the following areas every 8 hours of
actual use:
Back of Machine (Figure 51):
A. Horiz. Arbor Support Bearing (G3617 Only)
B. Horiz. Spindle Pulleys (G3617 Only) Must
open back access cover to do this.
B
Figure 51. Back of Machine Fittings.
Left Side of Machine (Figures 52–54):
C. Column/Knee Intersection
D. Longitudinal Feed Handwheel
E. Longitudinal Ways (Under Table)
F.
Cross Ways (Under Table)
G. Table Rotation (Front and Back)
H. Knee Feed Handwheel
36
Figure 52. Left side of mill, under table.
Figure 53. Longitudinal handwheel.
A
G
G
F
C
D
Figure 54. Front of mill.
G3616/G3617 Mill
E
H
K