Way Cover Installation; Handle Installation - Grizzly G3616 Owner's Manual

Way Cover
Installation
The way cover should be installed to protect and
keep the back portion of the cross ways clean.
Tools required:
Phillips Screwdriver, short handle ..................... 1
To install the way cover:
1.
Remove the four screws from the machine
at the way cover mounting location (Figure
11). Note: The two screws located near the
column use a nut and washer.
2.
Place the way cover on the machine and
align it with the fastener holes.
3. Attach the way cover with the four screws
removed in Step 1.
(two each side)
Figure 11. Way cover mounted in the correct
location on the machine.
G3616/G3617 Mill
Qty
Screws

Handle Installation

Tools required:
Flat Head Screwdriver ....................................... 1
Install and tighten the three handles on the
handwheels shown in Figure 12.
Handle Installation
Locations
Figure 12. Locations for handle installation.
Qty
21