Configuring Etherchannel Load Balancing - Cisco NM-8B-U - HW ROUTERS L-M User Manual

Configuration Tasks
Step 4
Router# show etherchannel 2 port-channel
Port-channel: Po2
------------
Age of the Port-channel
Logical slot/port
GC
Port state
Ports in the Port-channel:
Index
-------------------
1
0
Time since last port bundled:

Configuring EtherChannel Load Balancing

To configure EtherChannel load balancing, use the following commands in global configuration mode:
Command
Step 1
Router(config)# port-channel load-balance
{src-mac | dst-mac | src-dst-mac | src-ip |
dst-ip | src-dst-ip}
Step 2
Router(config)# end
Note For new load balancing to take affect, the EtherChannel must be first configured to the default
configuration.
Verifying EtherChannel Load Balancing
Step 1 Use the show etherchannel load-balance command to verify Layer 2 EtherChannel load balancing:
Router# show etherchannel load-balance
Source XOR Destination IP address
Router#
Cisco IOS Release 12.2(2)XT, 12.2(8)T, and 12.2(15)ZJ
58
16- and 36-Port Ethernet Switch Module for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series
Port-channels in the group:
----------------------
= 00h:23m:33s
= 10/2
= 0x00020001
= Port-channel Ag-Inuse
Load Port
55 Fa5/6
AA Fa5/7
Number of ports in agport = 2
HotStandBy port = null
00h:23m:33s Fa5/6
Purpose
Configures EtherChannel load balancing, use the no form of
this command to return EtherChannel load balancing to the
default configuration.
Exits configuration mode.