Information About The Basic Interface Parameters; Description; Beacon - Cisco 7604-RSP720C-R Configuration Manual

Information About the Basic Interface Parameters

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Information About the Basic Interface Parameters
This section includes the following topics:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

Description

For the Ethernet and management interfaces, you can configure the description parameter to provide a
recognizable name for the interface. Using a unique name for each interface allows you to quickly
identify the interface when you are looking at a listing of multiple interfaces.
For information on setting the description parameter for port-channel interfaces, see the
Port-Channel Description" section on page
interfaces, see the

Beacon

The beacon mode allows you to identify a physical port by flashing its link state LED with a green light.
By default, this mode is disabled. To identify the physical port for an interface, you can activate the
beacon parameter for the interface.
For information on configuring the beacon parameter, see the
on page
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
2-2
Description, page 2-2
Beacon, page 2-2
MDIX, page 2-3
Debounce Timer, page 2-3
Error Disabled, page 2-3
Rate Mode, page 2-4
Speed Mode and Duplex Mode, page 2-4
Flow Control, page 2-5
Port MTU Size, page 2-6
Bandwidth, page 2-7
Throughput Delay, page 2-7
Administrative Status, page 2-7
Unidirectional Link Detection Parameter, page 2-7
Carrier Delay, page 2-10
Port-Channel Parameters, page 2-10
Port Profiles, page 2-10
Time Domain Reflectometry Cable Diagnostics, page 2-12
"Configuring the Description" section on page
2-17.
Chapter 2
6-24. For information on configuring this parameter for other
2-16.
"Configuring the Beacon Mode" section
Configuring Basic Interface Parameters
"Configuring a
OL-23435-03