Cisco 7604-RSP720C-R Configuration Manual page 143

Chapter 5 Configuring Bidirectional Forwarding Detection
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
•
•
•
•
•
•
•
•
•
Configuring BFD on BGP
You can configure BFD for the Border Gateway Protocol (BGP).
BEFORE YOU BEGIN
Ensure that you are in the correct VDC (or use the switchto vdc command).
Enable the BFD feature. See the
Configure the BFD session parameters. See the
page 5-8
Enable the BGP feature. See the Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide,
Release 5.x, for more information.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
OL-23435-03
Configuring BFD on EIGRP, page 5-16
Configuring BFD on OSPF, page 5-18
Configuring BFD on IS-IS, page 5-19
Configuring BFD on HSRP, page 5-20
Configuring BFD on VRRP, page 5-21
Configuring BFD on PIM, page 5-22
Configuring BFD on Static Routes, page 5-23
Configuring BFD on MPLS TE Fast Reroute, page 5-24
Disabling BFD on an Interface, page 5-24
or the "Configuring BFD on an Interface" section on page
configure terminal
router bgp as-number
neighbor {ip-address | ipv6-address} remote-as as-number
bfd
(Optional) show running-config bgp
(Optional) copy running-config startup-config
"Enabling the BFD Feature" section on page
"Configuring Global BFD Parameters" section on
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
Configuring BFD
5-7.
5-9.
5-15