Connecting The Speakers - Yamaha RX-E100RDS Owner's Manual

GETTING STARTED
Never plug the AC power cord to the wall outlet until all connections are completed.
Follow the steps as shown below to connect the system using the supplied cords and accessories.
Right speaker
1
Connect the Speakers.
1 Unscrew the knob.
2 Remove approx. 5 mm (1/4") of insulation from
each of the speaker wires and insert the bare wire
into the terminal.
3 Tighten the knob to secure the wire.
Red: positive(+)
Black: negative(–)
2
Connect the AM Antenna.
Set up the AM loop antenna, then connect it.
GND AM ANT
E-4

Connecting the speakers

3
FM antenna
2
75 UNBAL
FREQUENCY
FM ANT GND AM ANT
STEP
B A E
R L
L
CD
TAPE
R
OUT IN IN
L
AUX
MD
R
6 MIN./SPEAKER
D C
SPEAKERS
1
2
1
3
AM loop antenna
SUBWOOFER SYSTEM
CONNETOR
OUT
4
3
Connect the FM Antenna.
75 UNBAL
FM ANT
4
Connect the AC power cord to a wall outlet.
• Use external FM/AM antennas if you need better reception.
Consult your dealer.
• The AM loop antenna should be placed apart from the main
unit. The antenna may be hung on a wall.
To Connect the Subwoofer (optional)
You can reinforce the bass frequencies by adding a
subwoofer (optional).
Connect the SUBWOOFER OUT terminal of the unit to
the INPUT terminal of the subwoofer.
Left speaker
To wall outlet