Surface Treatment System - Honeywell UV100E2009 - Ultraviolet Air Treatment System Owner's Manual

Ultraviolet system
Hide thumbs Also See for UV100E2009 - Ultraviolet Air Treatment System:
Table of Contents

Advertisement

Surface Treatment System

When installed next to the cooling coil of your system, your Ultraviolet Surface
Treatment System prevents a high percentage of the growth of micro-organisms such
as mold that may grow on duct surfaces, coils, and drain pans. Individual results
depend on careful installation and maintenance. See Fig. 2.
Your Ultraviolet Surface Treatment System operates a steady three-hours-on/
three-hours-off cycle. With Enviracom™ communication terminals hooked up,
your UV System turns off for the Winter 30 days after the last call for cooling occurs.
And your UV System turns on and resumes the on/off cycle with the first call for cooling
in the Spring.
EN T
SE M
RT IS
/A VE
et le
NI NG
nu e
W AR
pe au
pr en
!
ur la
co m
an ce
fs po
bi en
ai nt en
No ci
e et
lle z lir
la m
n et
Ve ui
al la tio
l'in st
Fig. 2. Typical Surface Treatment System installations.
You can capture and minimize micro-organisms passing through your forced air system
when you combine your UV System with a high-efficiency air filtration system like an
electronic air cleaner. Talk to your installer about adding an electronic air cleaner to
complement your UV System and provide added protection for you and your family.
Enviracom™ Communications Capabilities:
• Communicates with homeowner through three-wire communication bus using
24 Vac thermostat connections.
— Hooked up to Air Treatment System (single-bulb and dual-bulb) models: uses
thermostat load information instead of airflow sensor.
— Hooked up to Surface Treatment System model: uses thermostat load
information to operate during times evaporator coil may be exposed to
moisture to extend lamp life beyond two years.
• Sends messages to communicate reset and receives remote reset, when available.
— Bulb change indication cannot be reset by cycling power.
— When Enviracom is transmitting messages, shows flashing green Enviracom
LED on bottom of unit.
When Enviracom is transceiving messages, shows solid green Enviracom LED on
bottom of unit.
s
dr e
.
UV100E ULTRAVIOLET SYSTEM
3
NT
SE ME
ER TIS
IN G/ AV
les
WA RN
nu e et
!
la pe au
dre
mp ren
s po ur
bie n co
ce .
int en an
No cif
lire et
et la ma
Ve uil lez
lla tio n
l'in sta
M22860
69-1573—3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Uv100e3007 - uv surface treatment systemUv100e

Table of Contents