Table of Contents
Advertisement
RECORDING
RECORDING
{using deck I)
1.
Insert a blank tape.
2.
Set the DOLBY NR switch (i).
3.
Press the recording (REC ©} button ®.
4.
Select the recording source at the stereo amplifier.
5.
Adjust the recording level.
Adjust the REC LEVEL control @ so that the +3 dB mark
in the level meter fights up. The +6-dB mark may light up
momentarily.
6.
Press the playback (*) button @.
To start recording, the PAUSE (BE) button can be pressed
instead of the playback (B®) button @.
To Temporarily Stop Recording
° Press the PAUSE (8%) button @.
*
To resume recording, press the PAUSE (88) or playback
(P) button.
When Recording is Finished
Press the stop (™@) button @®.
SETTING THE RECORDING LEVEL
RECORD
MUTING
(creating blanks on the tape)
the music search operation.
* To resume recording, press the PAUSE (§M) or playback
(P) button.
DOLBY
NR SYSTEMS
NOTE:
RECORDING
USING MICROPHONE
(European modei only}
Set the DOLBY NR switch
Press the recording (@)} button ©.
Adjust the recording level and_balance.____
NOTES:
*
When a cassette without erasure prevention tabs is foaded, the
unit will not enter the recording mode when the recording but-
ton {@j is pressed.
* = Normalty feave the REC BALANCE control in the center click po-
sition. Adjust it if you want to change the relative recording levels
of the right and left channels.
5.
Press the playback (®) button @® or PAUSE {28} button
@ to start recording.
NOTE:
:
Be sure to disconnect the microphone plugs from the MIC-L/R jacks
@® when microphone recarding is not being carried out. Otherwise,
the sound
input at INPUT jacks cannot be recorded.
3
<RRB1046>
Advertisement
Table of Contents
