Front Panel Facilities - Pioneer CT-W510 Operating Instructions Manual

Stereo double-cassette deck
Hide thumbs Also See for CT-W510:
Table of Contents

Advertisement

FRONT PANEL FACILITIES
»
@
@
=
®
POWER
switch
PHONES jack
To insert headphones jack.
REC LEVEL control
DECK Il tape COUNTER
and RESET button
Resets the tape counter reading to ''000''.
{The tape COUNTER
works for deck II only.)
REC BALANCE control
Balances the recording level between Jeft (L) and right
{R) channels. (See page 9)
Record muting (MUTE} button (QO)
Pressing this button during recording, creates a blank
portion of approx. 4 seconds on the tape. The unit then
enters the recording pause mode.
PAUSE button (8&)
Stops tape transport temporarily during recording or
playback. Press the button again to resume operation.
(This can also be done by pressing
the Play (P) but-
@
3
EJECT button ( & )
Press to open the cassette door after you have pressed
the stop (™) button and the tape has stopped.
NOTE:
ff the power is turned off while the tape is moving, the cas-
sette door may remain locked. in this case, turn the power on
before pressing the EJECT button ( & }.
TIMER mode selector
OFF:
Normally, be sure to leave the selector in this position
except for repeat playback.
REC:
Set to this position for timer recording. (See page 12)
PLAY/REPEAT:
Set-to this position. for timer playback (See page 12),
and for repeat playback deck { or deck Il. (See page 10)
*
Recording or playback may suddenly start when
turning power on with this selector in the REC or
PLAY/REPEAT
position.
ton.) This button does not work during fast-forward and
rewind.
Recording (REC) button (@)
When the recording (@} button is pressed, the unit is
set to recording stancby mode. Press the PAUSE (88)
button or playback () button when ready to record.
The unit will not enter the recording standby if a cas-
sette with broken erasure prevention tabs is loaded.
Only deck Il is equipped with a recording function.
* When the selector is set to the PLAY/REPEAT posi-
tion and the unit is turned on with the POWER switch
@ or an audio timer, the unit automatically enters
the relay/blank skip mode (the [REC] indicator lights
up), in addition to the repeat mode. (See page 10.}
Ss
<RRB1046>

Advertisement

Table of Contents
loading

Table of Contents