Rear Wheel - Yamaha AG200FEM 2021 Owner's Manual

Periodic maintenance and adjustment
2
1
1
2
3
4
1. Brake shoe plate
5
2. Slot
3. Retainer
6
3. Insert the wheel axle from the right
side, and then install the axle nut.
7
4. Lower the front wheel so that it is
on the ground.
8
5. Connect the brake cable at the
brake shoe plate and then at the
handlebar lever holder.
9
6. Connect the speedometer cable
and install the clip.
10
7. Tighten the axle nut to the speci-
fied torque.
11
Tightening torque:
Axle nut:
12
39 N·m (3.9 kgf·m, 28 lb·ft)
8. Adjust the brake lever free play.
(See page 7-18.)
9. Slide the rubber cover back to its
3
original position.

Rear wheel

To remove the rear wheel
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
7-34
WARNING
1. Disconnect the brake torque rod
from the brake shoe plate by re-
moving the cotter pin, the nut, and
the bolt.
EAU25081
EAU56772
EWA10822