Troubleshooting - Yamaha AG200FEM 2021 Owner's Manual

Periodic maintenance and adjustment
To install the rear wheel
1
1. Install the drive chain slack adjust-
ing plate and the wheel by insert-
2 ing the wheel axle from the right
side.
3
TIP
Make sure that the drive chain slack ad-
justing plate is installed with the
4
punched side facing to the outside.
5 2. Install the axle nut.
3. Install the brake rod onto the brake
camshaft lever, and then install the
6
brake pedal free play adjusting nut
onto the brake rod.
7
4. Connect the brake torque rod to
the brake shoe plate by installing
the bolt and the nut, and then tight-
8
en the nut to the specified torque.
9
Tightening torque:
Brake torque rod nut:
19 N·m (1.9 kgf·m, 14 lb·ft)
10
5. Insert a new
11 WARNING! Always use a new
cotter pin.
[EWA10832]
6. Check and adjust the drive chain
12
slack. (See page 7-22.)
7. Check and adjust the brake pedal
free play. (See page 7-19.)
WARNING
After adjusting the brake pedal free
play, check the operation of the
brake light.
cotter pin.

Troubleshooting

Although Yamaha motorcycles receive
EWA10661
a thorough inspection before shipment
from the factory, trouble may occur dur-
ing operation. Any problem in the fuel,
compression, or ignition systems, for
example, can cause poor starting and
loss of power.
The following troubleshooting chart
represents a quick and easy procedure
for checking these vital systems your-
self. However, should your motorcycle
require any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the motorcycle
properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look like
Yamaha parts, but they are often inferi-
or, have a shorter service life and can
lead to expensive repair bills.
When checking the fuel system, do
not smoke, and make sure there are
no open flames or sparks in the ar-
ea, including pilot lights from water
7-36
WARNING
EAU25853
EWA15142