Reception - Kenwood TM-701A Instruction Manual

radio.
@ PF (Programmable Function) key
This key can be programmed to perform any of the fol-
lowing functions:
BAND key (Initial setting from the factory); or MHz key;
or SHIFT key; or TONE key; or REV key; or LOW key. 4-2-1. RECEPTION
To program the key use the following procedure:
1c
:
1. Turn the POWER switch on the transceiver OFF.
- Connect the power supply, antenna, and microphone and
2. Press and hold the key on the front panel of the
then adjust the controls as follows:
set that corresponds with the function you wish
Power Switch
OFF .
to program the microphone key to perform. Vol Control Full Counterclockwise
3. Turn on the POWER switch while the key on the
Fower switehiofipower'supply OFF
front panel is held in. (Fixed Station)
Audio confirmation is provided whenever a front panel key
is depressed. You can disable this function by pressing the
F key for longer than 1 second and then pressing the
REV/STEP key.
These buttons are used to activate the DTMF encoder. sceivers POWER switch. The display should indicate a
See 4-6-4. for further information on their use. frequency. Fig. 1 shows examples of frequencies that
@ LOCK key will appear on the various models. In addition to the fre-
quency you may see one or more control indicator turn
except the PTT function and DTMF keypad.
14