Mastering The Tm-732A/E; Mi Advanced Receive Functions; Simultaneous Reception Of Two Signal In The Same Band; Automatic Band Change) - Kenwood TM-732A Instruction Manual

SECTION 2. Mastering the TM-732A/E
Mi ADVANCED RESEIVE FUNCTIONS.
1. Simultaneous Reception of Two
Signal in the Same Band
This transceiver has been factory-programmed to
receive one VHF signal and one UHF signal at the
same time. It is also possible to receive two signals in
the same band at the same time. While displaying the
same band, two different signals can be selected.
oH: simultaneously receive two VHF band signals
Press the lower BAND SEL key.
i Press the F key, then press the C.SEL key within 10
seconds. V2 lights in the display, and the bottom
display also shows the second VHF band frequency.
() To simultaneously receive two UHF band signals
1. Press the upper BAND SEL key.
2. Press the F key, then press the C.SEL key within 10
seconds. U2 lights in the display, and the top
display also shows the second UHF band frequency.
Notes on simultaneous in Band reception
@ When two signals on the same band are received simultaneously,
the receive performance, such as image interference and
sensitivity, may be reduced.
@ If the two frequencies are the same, the volume may decrease at
some VOL control positions.
2. A.B.C.(Automatic Band Change)
The A.B.C. function automatically switches transmit
control from the RX/TX band to the RX only band
whenever a Signal is received that opens squelch on
the RX only band.
Press the F key, then press the MUTE/ABC key within
10 seconds.
The ABC indicator will appear in the display.
5020 |
a 10008 "
SHIFT OTSS TONE TALT REV STEP MUTE ABC,
If the transmit band is subsequently changed, the PTT
indicator will flash three times. This cancells the ABC
function
a
To return to normal operation
Press the F key, then press the C.SEL key within 10
seconds.
Note
When the incoming signal drops out the PTT function will return to the
previously selected position.
31