Demo Mode Setting; Exiting Demo Mode - Electrolux EWM09311 Service Manual

16 DEMO MODE SETTING

A special cycle allows demonstration of the operation of these appliances in shops, in a user interactive
manner, without connecting them to the water mains:
♦ The interactive mode consists of selecting one of the programmes, adding any options and, once the start
button has been pressed, the appliance will only perform certain of the phases of the programme, skipping
those that cannot be performed (water fill, drain, heating).
The cycle takes place as follows:
 the door lock is enabled as usual (door locked during operation, possibility of opening it at the end of the
cycle or when paused).
 Motor: all low speed movements are enabled, the pulses and spin are disabled,
 the water fill solenoid valves and the drain pump are disabled.
 Display: displays all the phases of the programme very quickly.
 Alarms: for safety reasons, the E40 (door closed), E50 (motor) and E90 (communication between
boards/configuration) families of alarms are enabled.
5. Set the selector dial to position 0 (zero).
6. Press the START/PAUSE button and the nearest option button simultaneously (as shown in the
figure).
7. Holding down the buttons, switch the appliance on by turning the programme selector three
positions clockwise.
8. Hold the buttons down until the LEDs start to flash (at least 3 seconds).
Where a display is fitted, the message "DEM" is shown for 2 seconds.

16.1 Exiting DEMO mode

Unplug the appliance from the mains socket.
Technical Support - DMM
Z 3
57/124
Z 6
599 75 58-67 Rev.04