5 DEMO MODE
A special cycle is designed to demonstrate the operation of these appliances in shops, without connecting them
to the water mains. This way, any one of the programmes can be selected and, once the start button/sensor
has been pressed/touched (START/PAUSE), the appliance will only perform some of the phases of the
programme, skipping those which cannot be performed (water fill, drain, heating).
The cycle takes place as follows:
The door lock is enabled as usual (door locked during operation, possibility of opening it at the end of the
cycle or when paused).
Motor: all low speed movements are enabled, the pulses and spin are disabled.
The water fill solenoid valves and the drain pump are disabled.
Display: as the cycle phases are very fast (one second in the demo cycle corresponds to approximately one
minute in the actual cycle) the end time decreases by 1 unit per second. Bear in mind that the end time
does not always correspond to the actual cycle time.
Accessing the DEMO setting for P6 and P3.0 stylings
5.1
The operations listed below must be carried out within 7 seconds.
STEPS
1
2
3
Simultaneously press the START/PAUSE button and the nearest option sensor
(as shown in the diagram).
Keep your finger above the sensors (for approximately three to five seconds) until:
P6 all the LEDs relating to Sensors S2/S3/S4 flash.
P3.0 the display indicates a flashing "dEM" for a short while.
Exiting DEMO mode
5.2
Disconnect the power supply to exit demo mode.
Technical Support - MDM
P6
Switch on the appliance using the ON/OFF button
Use sensor S1 to select the third LED from the top down
22/104
P3.0
599 77 39-16 Rev. 00