Setup Guide; Connections - Yamaha MY16-CII Owner's Manual

For yamaha my16-cii network i/o card

Hide thumbs Also See for MY16-CII:

Table of Contents

1. Setup Guide

In order to use the MY16-CII it is first necessary to set the appropriate bundle number and other

CobraNet parameters. This section will describe the procedure for using the CobraNet Manager

to make the initial CobraNet settings for the MY16-CII.

Note: Use the following methods to set up CobraNet devices other than the MY16-CII:

・ Use the DME Designer software to set up the DME8i-C/DME8o-C/DME4io-C.

・ Use the NetworkAmp Manager software to set up the ACU16-C/NHB32-C.

・ Use the on-board rotary switches to set up the MY16-C.

Or use the setup facilities provided for devices not listed above.

Begin by making the connections illustrated below in order to set up the CobraNet parameters

using the CobraNet Manager.

These connections are made specifically to set up the CobraNet parameters, and can be

changed later to suit system requirements.

Example 1: Simultaneous Setup of Multiple MY16-CII cards

The switching hub to which the MY16-CII cards are connected is connected to the computer via

an Ethernet straight cable.

Switching Hub

Ethernet Straight Cable

Computer

Figure 1: Connection Example 1

CobraNet Manager Lite for Yamaha Owner's Manual

Table of Contents

Cobranet manager lite