Advertisement
G Install the ME02R96 Expansion Kit
~The following instructions are intended for use by authorized serviceper-
sons only.~
This kit is not user-installable. Users should contact a local
Yamaha dealer or a service center to arrange for installation by a
Yamaha-authorized serviceperson.
Detach and Raise the Control Panel
When removing each screw, note its location and be sure to return it to the same place when reassem-
bling. Screws come in various sizes and are not interchangeable.
1.
Turn off the 02R96 power switch, and unplug the 02R96 power cord from the power supply.
2.
If SP02R96 side panels are installed on the 02R96, remove both of these panels (one from the
left, and the other from the right). To remove each panel, remove 6 screws as shown below
(for a total of 12 screws).
For more information about SP02R96 side panels, refer to the 02R96 owner's manual.
4
ME02R96
02R96
SP02R96
(Side Panel)
6 Screws
Advertisement
