Advertisement
FCC INFORMATION (U.S.A.)
1. IMPORTANT NOTICE: DO NOT MOD-
IFY THIS UNIT!
This product, when installed as indicated
in the instructions contained in this man-
ual, meets FCC requirements. Modifica-
tions not expressly approved by Yamaha
may void your authority, granted by the
FCC, to use the product.
2. IMPORTANT:
product to accessories and/or another
product use only high quality shielded
cables. Cable/s supplied with this prod-
uct MUST be used. Follow all installation
instructions. Failure to follow instructions
could void your FCC authorization to use
this product in the USA.
3. NOTE:
This product has been tested
and found to comply with the require-
ments listed in FCC Regulations, Part 15
for Class "B" digital devices. Compliance
with these requirements provides a rea-
sonable level of assurance that your use
of this product in a residential environ-
ment will not result in harmful interfer-
ence with other electronic devices. This
equipment generates/uses radio fre-
quencies and, if not installed and used
according to the instructions found in the
users manual, may cause interference
The above statements apply ONLY to those products distributed by Yamaha Corpora-
tion of America or its subsidiaries.
* This applies only to products distributed by YAMAHA CORPORATION OF AMERICA.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
When connecting this
harmful to the operation of other elec-
tronic devices. Compliance with FCC
regulations does not guarantee that
interference will not occur in all installa-
tions. If this product is found to be the
source of interference, which can be
determined by turning the unit "OFF"
and "ON", please try to eliminate the
problem by using one of the following
measures:
Relocate either this product or the
device that is being affected by the inter-
ference.
Utilize power outlets that are on different
branch (circuit breaker or fuse) circuits
or install AC line filter/s.
In the case of radio or TV interference,
relocate/reorient the antenna. If the
antenna lead-in is 300 ohm ribbon lead,
change the lead-in to co-axial type
cable.
If these corrective measures do not pro-
duce satisfactory results, please contact
the local retailer authorized to distribute
this type of product. If you can not locate
the appropriate retailer, please contact
Yamaha Corporation of America, Elec-
tronic Service Division, 6600 Orangetho-
rpe Ave, Buena Park, CA90620
(class B)
Advertisement
