Table of Contents
Advertisement
Symptoms
The product is
parked for hours in
the charging station.
The cutting result is
not satisfactory.
The battery is empty
and you put the prod-
uct in the charging
station, but it does
not charge and can-
not be set to ON.
7.4 Finding breaks in the loop wire
Breaks in the loop wire are usually the result of
unintentional physical damage to the wire such as when
gardening with a shovel. In countries with ground frost,
also sharp stones that move in the ground can damage
the wire. Breaks can also occur due to the wire being
stretched excessively during installation.
Mowing the grass too low right after the installation can
damage wire insulation. Damage to the insulation may
not cause disruptions until several weeks or months
later.
CAUTION:
cutting height the first weeks after
installation and then lower the height one
step at a time every second week until the
desired cutting height has been reached.
2369 - 001 - 05.02.2024
Cause
The product has operated the maximum cut-
ting time for the day.
The hatch is closed but the START button is
not pushed.
Parking mode is enabled.
The product does not operate if the battery
temperature is too high or too low.
The product operates for a small number of
hours per day.
For the shape of the work area it is necessa-
ry to adjust the settings for
to cover all parts of the work area.
The work area is too large.
Blunt blades.
Long grass in relation to the set cutting
height.
Collection of grass on the blade disc or
around the motor shaft.
If the battery has been deeply discharged,
it will take a long time to charge the battery
and before the product can be set to ON.
Always select the maximum
Action
No action. Refer to
Push the STOP button to open the hatch.
Enter the PIN code and confirm with the OK
button. Push the START button and then
close the hatch.
Change the operating mode. Refer to
ating modes - Start on page 25 .
Make sure that the charging station is put in
an area with protection from the sun.
Increase the cutting time. Refer to
on page 20 .
Change the settings of the areas where the
Lawn Coverage
product starts to cut and how often. Refer to
Lawn coverage on page 22 .
Decrease the size of the work area or extend
the schedule. Refer to
Replace all the blades. Refer to
ment of the blades on page 30 .
Increase the cutting height and then lower it
when the grass is shorter.
Remove the collection of grass and clean the
product. Refer to
28 .
Keep the product in the charging station for
24 hours and test if the product can be set
to ON. If the problem stays, speak to your
authorized service technician.
A damaged splicing of the loop wire can also lead to
disruptions several weeks after the splice was done.
A faulty splice can, for example, be the result of the
coupler not being pressed together hard enough with a
pair of pliers, or that a coupler of lower quality than the
original coupler has been used.
Note:
Please first check all known splices before
further troubleshooting is done.
A wire break can be located by gradually halving the
distance of the loop where the break may have occurred
until there is only a very short section of the wire left.
The following method does not work if
activated. Make sure first that
ECO mode on page 21 .
Refer to
1.
Check that the indicator lamp in the charging
station flashes blue, which indicates a break in
Schedule on page 20 .
Oper-
Schedule
Schedule on page 20 .
Replace-
Clean the product on page
ECO mode is
ECO mode is turned off.
Troubleshooting - 39
Advertisement
Table of Contents
