Table of Contents
Advertisement
3.5 Installation of the product
3.5.1 Installation tools
•
Hammer/plastic mallet: To simplify putting the
stakes into the ground.
•
Edge cutter/straight spade: To bury the boundary
wire.
•
Combination pliers: For cutting the boundary wire
and pressing the connectors together.
•
Adjustable plier: For pressing the couplers
together.
3.5.2 To install the Automower
app
1.
Download the Automower
mobile device.
2.
Sign up for a Husqvarna account in the
®
Automower
Connect app.
3.
An e-mail is sent to the registered e-mail address.
Follow the instructions in the e-mail in less than 24
hours to validate your account.
4.
Log in to your Husqvarna account in the
®
Automower
Connect app.
3.5.3 To start the product for the first time
When the product is set to ON for the first time, there
are some basic settings to do before the product can
start to operate.
16 - Installation with wire
D
A
B
C
®
Connect
®
Connect app on your
1.
Push the jog wheel for 3 seconds to set the
product to ON.
Note:
The Bluetooth
of the product is enabled for 3 minutes. If the
pairing operation between the product and the
mobile device is not completed correctly, use the
jog wheel to select Bluetooth
2.
Enter the factory PIN code 1234 on the product.
3.
Log on to your Husqvarna account in the
®
Automower
Connect app.
®
4.
Start Bluetooth
on your mobile device.
My mowers in the Automower
5.
Select
app, and add your product.
6.
Follow the instructions in the Automower
app.
Note:
Husqvarna recommends to change the factory
PIN code to a new PIN code in the app.
3.5.4 To install the charging station
CAUTION:
the charging station plate.
CAUTION:
baseplate of the charging station.
WARNING:
the low-voltage cable and the power supply
unit are clean and dry before you connect
them.
When connecting the power supply, only use a power
outlet that is connected to an residual-current (RCD)
device.
1.
Read and understand the instructions about the
charging station. Refer to
the charging station on page 12 .
2.
Put the charging station in the selected area.
Note:
Do not attach the charging station to the
ground with the screws until the guide wire is
installed. Refer to
18 .
3.
Open the hatch on the front of the charging station.
4.
Attach the top of the charging station.
®
pairing operation mode
®
to enable it again.
®
Connect
®
Do not make new holes in
Do not put your feet on the
Make sure that the plugs of
To examine where to put
To install the guide wire on page
2369 - 001 - 05.02.2024
Connect
Advertisement
Table of Contents
