Advertisement
7
HOW TO RESOLVE COMMON ERRORS
In the right conditions, Miimo should normally operate without any errors. However, if
an error occurs then Miimo will stop operating and when you open the display screen
the LED will be blinking
red
(if the battery is greater than 30%) or OFF (if the battery
is less than 30% Miimo will automatically switch off in case of error).
If the LED is blinking red, please carry out the following procedure:
7.1
Visually identify and correct the error. For example:
If Miimo is in a hole in the ground, move Miimo away from the hole
•
and repair the hole
If Miimo is tilted at a large angle, put Miimo on flat ground
•
If Miimo is outside the boundary wire, put Miimo back inside the
•
boundary wire
7.2
Make a short press on the "Mode/Activate" (
7.3
If the error has been successfully cleared the LED will turn to
green
/
blue
/ yellow
yellow
/
orange
can be used as normal
7.4
If the error has not been successfully cleared, hold the display
screen with one hand and push Miimo's top cover as far forward
as possible with the other
7.5
If the error still has not been cleared, please connect to Miimo using
the Mii-monitor app, and a pop-up message will appear on the home
screen to explain the cause of the error and the next steps
7.6
If you are still unable to clear the error then please contact your
Honda Authorised Dealer
If the LED is OFF and Miimo has stopped operating, please follow the procedure
in the next section.
12
) button
(depending on the mode) and Miimo
8
SWITCH MIIMO ON AND ENTER PIN
HRM1000 will turn OFF in the following situations:
User switches Miimo OFF (e.g.: for winter storage)
•
Miimo is in error and battery level reduces to less than 30%
•
(e.g.: Miimo is stuck in the garden)
Miimo is not in error and battery level reduces to 0% (e.g.: runs out of
•
battery while moving in the garden)
To start using Miimo again, you will need to switch it ON and enter the PIN.
Please switch Miimo ON by pressing the "ON-OFF" (
the docking station if Miimo is out of battery. The LED should be blinking white
(if not, your Miimo's time and date may need resetting, so please follow section
3 above). From here you have 2 options:
8.1
Open Mii-monitor app, login (if necessary) and connect to Miimo by
Bluetooth from the My Miimo screen (as per section 2.3 above). Mii-
monitor will then ask you to enter your PIN code. After entering the
PIN code, the LED will change to
(depending on the mode). You can now use Miimo as normal.
8.2
Or type the PIN on Miimo display screen by tapping the "Home" (
button the correct quantity of times for each digit of the PIN code.
Each digit input should be separated by tapping the "Mode/Activate"
(
) button once. For example, the diagram below shows how to
enter the PIN code 1 2 3 4 on the display. To enter a "0" value, simply
tap the "Mode/Activate" (
button. If you make a mistake, press the "ON-OFF" (
and start again.*
) button or put Miimo in
blue
/
green
/ yellow
yellow
/
orange
)
) button without tapping the "Home" (
)
) button
13
Advertisement
