Panasonic ES-GA21 - Rechargeable Shaver Manual

Panasonic ES-GA21 - Rechargeable Shaver Manual

Also See for ES-GA21:

Advertisement

Panasonic ES‑GA21 - Rechargeable Shaver Manual

Before operating this unit, please read these instructions completely.

SPECIFICATIONS

Power source: See the name plate on the product. (Automatic voltage conversion)

Motor voltage: 3.6 V DC

Charging time: 1 hour

This product is intended for household use only.

Parts identification

Parts identification

  1. Protective cap
  2. Outer foil section
    1. Foil frame
    2. System outer foil
    3. System outer foil release buttons
  3. Inner blades
  4. Main body
    1. Foil frame release buttons
    2. OFF/ON switch
    3. Lock ring
    4. Battery capacity lamp ()
    5. Charge status lamp ()
    6. Appliance socket
    7. Trimmer
    8. Trimmer handle
  5. Adaptor (RE7‑51)
    1. Power cord
    2. Appliance plug
  6. Travel pouch

Charge

Charging

  1. Insert the appliance plug into the shaver.
  2. Plug in the adaptor into a household outlet.
    • glows and charging starts.
    • Charging is completed when blinks.
      (Max. 1 hour later)
    • If the shape of the plug does not fit the power outlet, use an attachment plug adaptor of the proper configuration.

Using the lock ring

Use the lock ring to lock or unlock the OFF/ON switch.
  1. Rotate the lock ring until it clicks.

    Unlock the OFF/ON switch:
    For when shaving, washing the shaver, lubricating the shaver.

    Lock the OFF/ON switch:
    For when carrying the shaver.

About the lamp

While charging

Glows red.

After charging is completed

Blinks red once every second.

10 minutes after charging is completed

Blinks red once every 2 seconds.

When the battery capacity is low
When the battery capacity is low
blinks

  • A full charge will supply enough power for approx. 14 shaves of 3 minutes each.

Using the trimmer

Slide the trimmer handle up. Place at a right angle to your skin and move downwards to trim your sideburns.

Using the shaver

Using the shaver

  1. Rotate the lock ring and press the OFF/ON switch.
  2. Hold the shaver as illustrated above and shave.
  • Start out shaving by applying gentle pressure to your face. Stretch your skin with your free hand and move the shaver back and forth in the direction of your beard. You may gently increase the amount of pressure as your skin becomes accustomed to this shaver. Applying excessive pressure does not provide a closer shave.

Clean

Cleaning

  1. Disconnect the power cord from the shaver.
  2. Apply some hand soap and some water to the outer foil.
  3. Rotate the lock ring to unlock the OFF/ON switch.
  4. Press the OFF/ON switch for more than 2 seconds to activate the turbo mode for "sonic" vibration cleaning.
    • or flash around randomly.
    • After about 20 seconds, it will be automatically turned off, or you can turn it off by pressing the OFF/ON switch.
  5. Remove the outer foil section and press the OFF/ON switch for more than 2 seconds to activate the turbo mode for "sonic" vibration cleaning and clean it with running water.
  6. Wipe off any drops of water with a dry cloth.
  7. Dry the outer foil section and the shaver completely.


for turbo mode

  • Shaving in turbo mode may damage your skin. Turn the shaver off and then on again to cancel turbo mode.
  • Do not place your fingers on the OFF/ON switch while using the shaver. This may cause the shaver to turn off or enter turbo mode.

Replacing the system outer foil and the inner blades

system outer foil once every year
inner blade once every two years

Replacing the system outer foil

  1. Press the foil frame release buttons and lift the outer foil section upwards as illustrated.
  2. Press the system outer foil release buttons and pull down the system outer foil as illustrated.
  3. Insert the system outer foil until it clicks.
    • Always attach the system outer foil in proper direction.
    • Always insert the system outer foil to the foil frame when attaching to the shaver.

Replacing the inner blades

  1. Press the foil frame release buttons and lift the outer foil section upwards as illustrated.
  2. Remove the inner blades one at a time as illustrated.
    • Do not touch the edges (metal parts) of the inner blades to prevent injury to your hand.
  3. Insert the inner blades one at a time until they click as illustrated.

Removing the built-in rechargeable battery


for Lithium Battery:
Fire, explosion, and severe burn hazard. Do not crush, disassemble, heat above 100°C (212°F), or incinerate.

Remove the built‑in rechargeable battery before disposing of the shaver. Do not dismantle or replace the battery so that you can use the shaver again. This could cause fire or an electric shock. Replace it at an authorized service center.

  • Disconnect the power cord from the shaver when removing the battery.
  • Perform steps 1 to 5 and lift the battery, and then remove it.

FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL-FREE (IN USA ONLY) NATIONAL ACCESSORY PURCHASE HOT LINE AT 1-800-332-5368.

IN CANADA, CONTACT PANASONIC CANADA INC. AT THEIR ADDRESS OR TELEPHONE NUMBER.

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic precautions should always be followed, including the following:

Read all instructions before using this appliance.


To reduce the risk of electric shock:

  1. Do not reach for an appliance that has fallen into water. Unplug immediately.
  2. Charger unit is not for immersion or for use in shower.
  3. Do not place or store appliance where it can fall or be pulled into a tub or sink. Do not place in or drop into water or other liquid.
  4. Except when charging, always unplug this appliance from the electrical outlet immediately after using.
  5. Unplug this appliance before cleaning.
  6. Do not use an extension cord with this appliance.


To reduce the risk of burns, fire, electric shock, or injury to persons:

  1. Close supervision is necessary when this appliance is used by, on, or near children or invalids.
  2. Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
  3. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the appliance to a service center for examination and repair.
  4. Keep the cord away from heated surfaces.
  5. Never drop or insert any object into any opening.
  6. Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
  7. Do not use this appliance with damaged shaving blades and/or foil, as facial injury may occur.
  8. Always attach plug to appliance first, then to outlet. To disconnect, turn all controls to "off" then remove plug from outlet.

SAVE THESE INSTRUCTIONS

Before use

This WET/DRY shaver can be used for wet shaving with shaving lather or for dry shaving. You can use this watertight shaver in the shower and clean it in water. The following is the symbol of Wet shaver. The symbol means that the hand‑held part may be used in a bath or shower.

Treat yourself to wet lather shaves for at least three weeks and notice the difference. Your Panasonic WET/DRY shaver requires a little time to get used to because your skin and beard need about a month to adjust to any new shaving method.

Using the shaver


The outer foil is very thin and can be damaged if not used correctly. Check that the foil is not damaged before using the shaver. Do not use the shaver if the foil or blades are damaged as you will cut your skin.

Charging the shaver

Do not use any power cord or AC adaptor other than one specifically designed for this model (RE7‑51). Plug in the adaptor into a household outlet where there is no moisture and handle it with dry hands. The shaver may become warm during use and charging. However, this is not a malfunction. Do not charge the shaver where it will be exposed to direct sunlight or other heat sources. Hold the adaptor when disconnecting it from the household outlet. If you tug on the power cord, you may damage it. The supply cord cannot be replaced. If the cord is damaged, the appliance should be scrapped.

Adequate ambient temperature for charging is 15‑35°C (59‑95°F).

If the plug symbol does not glow initially when the shaver is plugged in, wait for a short while until it does.

The adaptor is intended to be correctly oriented in a vertical or floor mount position.

Cleaning the shaver


Disconnect the power cord from the shaver before cleaning it to prevent electric shock.

Keep both the inner blades inserted. If only one of the inner blades is inserted, the shaver may be damaged. If you clean the shaver with water, do not use salt water or hot water. Do not soak the shaver in water for a long period of time. Wipe it with a cloth dampened with soapy water. Do not use thinner, benzine or alcohol.

Storing the shaver

Disconnect the power cord when storing the shaver. Do not bend the power cord or wrap it around the shaver. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

Keep these operating instructions in a safe place.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Panasonic ES-GA21 - Rechargeable Shaver Manual

Advertisement

Need Assistance?

Do you have a question about the ES-GA21 that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Table of Contents