Parts identification
- Protective cap
- Outer foil section
- Foil frame
- System outer foil
- System outer foil release buttons
- Inner blades
- Main body
- Foil frame release buttons
- Pivot action selector
- Lock ring
- Battery capacity lamp
- Charge status lamp ()
- Appliance socket
- Power switch [0/1]
- Thumb rest
- Trimmer
- Trimmer handle
- AC adaptor (RE7‑59)
- Power cord
- Appliance plug
- Travel case
Using the lock ring Use the lock ring to lock or unlock the power switch. Rotate the lock ring until it clicks. Rotate the lock ring to "" to unlock the power switch: For when shaving, washing the shaver, lubricating the shaver. Rotate the lock ring to "" to lock the power switch: For when carrying the shaver. |
Charge
Charging the shaver
- Insert the appliance plug into the shaver.
- Plug in the AC adaptor into a household outlet.
- Turn the shaver off before attaching.
- Charging is completed after approx. 1 hour.
- If the shape of the plug does not fit the power outlet, use an attachment plug adaptor of the proper configuration.
You cannot operate the shaver while charging.
Reading lamps when charging
While charging
The charge status lamp () glows. The number of the battery capacity lamp will increase as charging progresses.
After charging is completed
All the lamps will light up and then turn off after 5 seconds.
- After charging is completed, turning the power switch ON with the shaver plugged in will cause all the lamps to light up and then turn off after 5 seconds. This shows that the shaver is fully charged.
- Recommended ambient temperature for charging is 5‑35°C (41‑95°F). The battery may not charge properly or not at all under extreme low or high temperatures.
The charge status lamp () will blink when there is a problem with charging. - When charging the shaver for the first time or when it has not been in use for more than 6 months, the charge status lamp () may not glow. It will eventually glow if kept connected.
Shave
Using the shaver
- Rotate the lock ring to unlock the power switch and press the power switch.
- Hold the shaver as illustrated above and shave.
- We recommend using the shaver in an ambient temperature range of 5 ‑ 35°C (41 ‑ 95°F). If used outside this range, the appliance may stop operating.
Start out shaving by applying gentle pressure to your face. Stretch your skin with your free hand and move the shaver back and forth in the direction of your beard. You may gently increase the amount of pressure as your skin becomes accustomed to this shaver. Applying excessive pressure does not provide a closer shave. |
- If you press the power switch for more than seconds, the sonic vibration cleaning mode is activated. You cannot shave in this mode.
- Do not place your fingers on the power switch while using the shaver. This may cause the shaver to turn off or enter the sonic vibration cleaning mode. Place your thumb on the thumb rest while using the shaver.
|
Pivot action selector Use to select "SOFT" (soft) or "LOCK" (lock). You can change the pivot action whether the shaver is turned on or off. |
Using the trimmer Slide the trimmer handle up. Place at a right angle to your skin and move downwards to trim your sideburns. |
Specifications
Power source | See the name plate on the AC adaptor. (Automatic voltage conversion) |
Motor voltage | 3.6 V |
Charging time | Approx. 1 hour |
This product is intended for household use only.
FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL‑FREE (IN USA ONLY) NATIONAL ACCESSORY PURCHASE HOTLINE AT 1‑800‑332‑5368.
IN CANADA, CONTACT PANASONIC CANADA INC. AT THEIR ADDRESS OR TELEPHONE NUMBER.
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed, including the following:
Read all instructions before using this appliance.
To reduce the risk of electric shock:
- Do not reach for an appliance that has fallen into water. Unplug immediately.
- Charger unit is not for immersion or for use in shower.
- Do not place or store appliance where it can fall or be pulled into a tub or sink. Do not place in or drop into water or other liquid.
- Except when charging, always unplug this appliance from the electrical outlet immediately after using.
- Unplug this appliance before cleaning.
- Do not use an extension cord with this appliance.
To reduce the risk of burns, fire, electric shock, or injury to persons:
- Close supervision is necessary when this appliance is used by, on, or near children or invalids.
- Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
- Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the appliance to a service center for examination and repair.
- Keep the cord away from heated surfaces.
- Never drop or insert any object into any opening.
- Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
- Do not use this appliance with damaged shaving blades and/or foil, as it has the potential to result in facial injury.
- Always attach plug to appliance first, then to outlet. To disconnect, turn all controls to "off" then remove plug from outlet.
SAVE THESE INSTRUCTIONS
This shaver has a built‑in rechargeable battery. Do not throw into fire, apply heat, or charge, use, or leave in a high temperature environment.
Before use
This WET/DRY shaver can be used for wet shaving using shaving lather or for dry shaving. You can use this watertight shaver in the shower and clean with water. The following symbol means suitable for use in a bath or shower.
Treat yourself to wet lather shaves for at least three weeks and notice the difference. Your Panasonic WET/DRY shaver requires a little time to get used to because your skin and beard need about a month to adjust to any new shaving method.
Using the shaver
The outer foil is very thin and can be damaged if not used correctly. Check that the foil is not damaged before using the shaver. Do not use the shaver if the foil is damaged as you will cut your skin.
- Terminate the usage when there is an abnormality or failure.
- Do not share your shaver with your family or other people. Doing so may result in infection or inflammation.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
Charging the shaver
- Never use the AC adaptor in the bathroom or shower room.
- Do not use any power cord or AC adaptor other than the AC adaptor (RE7‑59).
- Plug in the AC adaptor into a household outlet where there is no moisture and handle it with dry hands.
- Hold the AC adaptor when disconnecting it from the household outlet. If you tug on the power cord, you may damage it.
- The supply cord cannot be replaced. If the cord is damaged, the AC adaptor should be scrapped.
- The AC adaptor is intended to be correctly oriented in a vertical or floor mount position.
Cleaning the shaver
Disconnect the power cord from the shaver before cleaning it in water to prevent electric shock.
- Keep both the inner blades inserted. If only one of the inner blades is inserted, the shaver may be damaged.
- If you clean the shaver with water, do not use salt water or hot water. Do not soak the shaver in water for a long period of time.
- Clean the housing only with a soft cloth slightly dampened with tap water or soapy tap water. Do not use thinner, benzine, alcohol or other chemicals.
Storing the shaver
- Store the shaver in a place with low humidity after use.
- Do not store the shaver where it will be exposed to direct sunlight or other heat sources.
- Disconnect the power cord when storing the shaver.
- Do not bend the power cord or wrap it around the shaver.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Need Assistance?
Do you have a question about the ES-LF51 that isn't answered in the manual? Leave your question here.