Table of Contents
Advertisement
Level 2 Service Manual
Removing and Replacing the LCD Module
6881040B85
1.
Remove the rear housing cover, battery, antenna, endo housing, and front endo
housing as described in the procedures.
2.
Use the disassembly tool to unlatch the metal locking tabs on the LCD bracket.
3.
Lift the bottom end of the LCD bracket away from the LCD until the tabs at
the top of the LCD bracket are clear of the plastic.
4.
Lift the LCD bracket away from the LCD module and set aside for reuse.
5.
Use the plastic tweezers to remove the LCD module from the front endo
housing.
A
B
Figure 13. Removing the LCD Module
6.
To replace, align the LCD module to the front endo housing. Ensure that the
LCD revision number is visible at the bottom left side of the LCD module.
7.
Insert the top tabs of the LCD bracket into the front endo housing.
8.
Lower the bottom end of the LCD bracket onto the front endo housing and
gently press the LCD bracket against the front endo housing until the metal
locking tabs snap into position.
9.
Replace the endo housing, endo assembly, antenna, battery, and rear housing
cover as described in the procedures.
July 19, 2002
Disassembly
020454o
25
Advertisement
Table of Contents
Troubleshooting
