Table of Contents
Advertisement
Level 2 Service Manual
Removing and Replacing the Endo Assembly
6881040B85
1.
Remove the rear housing cover, battery, and antenna as described in the
procedures.
2.
Bend the side grips slightly outward as indicated by the arrows in Figure 7A
to release the endo housing latches.
3.
Lift the bottom end of the endo housing out of the front housing followed by
the top end of the front housing as shown in Figure 7B.
SIDE GRIPS
A
ENDO HOUSING
B
Figure 7. Removing and Replacing the Endo Assembly
4.
To replace, insert the top end of the endo assembly into the front housing.
5.
Press the bottom end of the endo assembly into the front housing until it snaps
into place.
6.
Replace the antenna, battery, and rear housing cover as described in the
procedures.
July 19, 2002
Disassembly
SIDE GRIPS
020468
19
Advertisement
Table of Contents
Troubleshooting
