Advertisement
Quick Links
How to Remove and Reposition a Honeywell Smoke Detector Model 5806WE
Description
This page shows how to remove and reposition a Honeywell Smoke Detector Model 5806W3
Please read through the directions in its entirety before commencing.
Preparation
***IMPORTANT customers who use myadt.ca*** Before removing the sensor, place the
panel on test mode through
1. Tap [Home]
2. Tap [Place on Test]
3. Enter your expiration date and time
4. Enter your password
5. Tap [Yes-Proceed]
Parts Required
1. A Phillips screwdriver
2. A thin sharp knife
myadt.ca. After logging in:
Advertisement
Related Manuals for Honeywell 5806WE
Summary of Contents for Honeywell 5806WE
- Page 1 How to Remove and Reposition a Honeywell Smoke Detector Model 5806WE Description This page shows how to remove and reposition a Honeywell Smoke Detector Model 5806W3 Please read through the directions in its entirety before commencing. Preparation ***IMPORTANT customers who use myadt.ca*** Before removing the sensor, place the panel on test mode through myadt.ca.
- Page 2 Removal of Smoke Sensor 1. Grab the face of the smoke detector and twist to the left to release from the backplate 2. Arm and disarm the alarm to clear panel alert 3. Determine if the backplate is attached with adhesive tape or screwed in a.
- Page 3 5. Arm and disarm the alarm to clear panel alert ***If the alert does not clear or if the panel sensor shows tamper, walk through the steps above once more. It could be the sensor cover is not on properly***...