Electrolux 7 Series Service Manual page 96

13.7.4 Motor
1
2
Remove the back panel (see relevant chapter).
Remove the belt (see relevant paragraph).
1
Loosen the two front fastening screws (1) and the rear ones (2).
Disconnect the connectors: for the power supply and earthing
When reassembling, restore the connections.
If the clamp securing the wiring to the motor breaks, replace it with a new one.
Tighten the screws at a torque of 5 Nm.
13.7.5 Heating
Remove the back panel (see relevant chapter).
3
2
Disconnect the connectors of the heating element (1) and NTC probe (2).
Loosen the nut (3) and pull it out.
1
1
Tighten the nut at a torque of 4 Nm.
13.7.6 Aqua control
Remove the back panel (see relevant chapter).
Release the hooks securing it to the bottom and disconnect the connector.
13.7.7 Rear shock absorber
Remove the back panel (see relevant chapter).
To take the pins out of their seats, push the locking tooth and at the same time
remove it with pliers.
Perform the same operations for the other pin.
Take the shock absorber out.
2010 dmm 96/96 599 73 68-54