Electrolux 7 Series Service Manual page 90

13.4.4 Drain water circuit
• Tub drain pipe
Remove the worktop (see relevant paragraph).
Remove the control panel (see relevant paragraph).
Remove the iron ring securing the bellow seal to the front panel.
Unfasten the screws securing the door safety interlock (see related paragraph).
Remove the front panel (see relevant paragraph).
Pull out the main drain pipe (1)
Loosen the screw of the clamp securing the tub drain pipe to the tub (2)
Pull out the pipe from the analogue pressure switch connecting the pressure
chamber.
Release the pressure chamber (See pressure chamber description)
Pull out the tub drain pipe and pull out the pressure chamber (3).
Where clamps are present, you will need to open/break them. When reassembling, use clamps with the same characteristics.
13.4.5 Pressure chamber
Remove the worktop (see relevant paragraph).
Remove the control panel (see relevant paragraph).
Remove the iron ring securing the bellow seal to the front panel.
Unfasten the screws securing the door safety interlock (see related paragraph).
Remove the front panel (see relevant paragraph).
Pull out the pipe from the analogue pressure switch and hooks securing it to the
welded tub.
Unfasten the screw in the clamp that fixes the drain pipe to the welded tub and
remove it from its position, pulling it out.
Push the hook (1) while at the same time lifting the chamber (2) from the
support securing it to the tub.
Turn the chamber under the tub and pull it out.
2010 dmm 90/96
3
2
2
1
1
1
1
599 73 68-54