Removing The Cutting Unit (Model 04865); Backlapping The Cutting Unit - Toro Greensmaster e1021 Operator's Manual

1. Socket-head screw
2. Spacer
3. Washer
4. Remove the socket-head screws that secure the
cutting unit to the frame
1. Socket-head screw
5. Remove the cutting unit from the frame.
Removing the Cutting Unit
(Model 04865)
Note:
The hex tube disengages if you engage the
reel drive when the cutting unit is removed.
1. Move the kickstand to the C
position.
2. Remove the grass basket (if equipped).
3. Move the collar
transmission-shaft groove.
Note:
This releases tension from the spring.
Figure 40
4. Spring washer
5. Coupler
6. Nut
(Figure 41).
Figure 41
-U
UTTING NIT
(Figure 42) into the
4. Slide the hex tube off of the cutting-unit coupler
shaft
g333165
1. Collar
2. Hex tube
g343380
5. Move the suspension latches up to release the
cutting unit from the machine
6. Remove the cutting unit from the frame.
Backlapping the Cutting
Unit
To backlap the cutting unit, perform 1 of the following
options:
•
Install the Access Backlap Kit (Model 139-4342)
-S
ERVICE
and use a backlapping machine. Contact your
authorized Toro distributor to acquire this kit.
•
Use the InfoCenter to enter Backlap Mode.
To enter Backlap Mode, select B
S
ERVICE
backlap the cutting unit.
37
(Figure 42).
Figure 42
3. Coupler shaft
4. Latches
menu. Follow the InfoCenter prompts to
g307907
(Figure 42).
from the
ACKLAP