Maintaining the Battery-Charger
Cords
•
Clean the cords with a slightly damp cloth after
each use.
•
Coil the cords when not in use.
•
Periodically examine the cords for damage, and
replace them when necessary with Toro-approved
parts.
Cleaning the Battery-Charger Case
Clean the case with a slightly damp cloth after each
use.
Replacing Fuses
If the machine does not turn on, even after charging,
check the machine fuses as follows:
1.
Turn off the machine and disconnect the battery
pack.
2.
Remove the 4 screws
the battery-pack cover and remove the cover.
Figure 31
1. Screws
3.
Check the fuses in the fuse block
(Figure
31) that secure
g464537
2. Fuse block
(Figure
32).
1. Motor (30 A)
2. Work lights (2 A)
4.
If any fuse is blown, replace them with a fuse of
the appropriate voltage and amperage. Refer to
the traction unit Service Manual for specific fuse
part numbers.
Important:
All fuses on the machine are
rated for 80 V. Do not use 12 V automotive
fuses.
Acknowledging the Battery
Interface Panel
The battery interface panel emits lights that indicate
the battery state, including charging status, state of
charge, faults, and battery updates. Refer to your
authorized Toro distributor for more information about
the battery interface panel.
33
Figure 32
3. Electrical power (2 A)
g464538