Sony RDR-VX515 Operating Instructions Manual page 47

5 Press REC NODE repeatedly to select the
recording
mode.
The display changes on tile TV screen as
follows:
HQ ==_ HSP =_ SP =_ LSP
f
SEP_ SLP _EP_ LP
For details about the recording mode, see
page 45.
6 Press• REC.
Recording starts.
Recording continues until you stop the
recording or the disc is full.
To stop recording
Press • STOP.
Note that it may take a few seconds for the
recorder to stop recording.
To pauserecording
Press II PAUSE.
To restart recording, press I| PAUSE again.
To watch anotherTV program while recording
1 Slide the TV/DVD.V1DEO switch to TV.
2 Press TV/V1DEO to set the TV to the TV
input.
3
Select another channel on the TV.
To watch a VHS tape while recording
Press VIDE() to operate Ihe VCR, insert a tape,
then press I2:> PLAY.
"_i° Hints
• To plly a disc recorded with this recorder ol3other
equipmenL finalize the disc (page 86).
• You can use the number buttons lbr channel selection.
Enter the channel number, and press SET.
• You can select a video source from Ihe LINE 1 IN or
LINE 2 INjacks using the INPUT SELECT button.
• You can turn off the TV during recording. If you are
using a cahle box or a satellite receiver, make sure to
leave it oil.
• You cannol change Ihe channel or input source during
recording.
Recording using the Quick Timer
(0ne-t0uch Timer Recording)
You car, set the recorder Io record in 30-minute
increments.
1
PressDVDto oparate the DVDrecorder.
2 Press• RECrepeatedly t o setthe
duration.
Each press increases the lime hy 30 minutes,
up to eighl hours (12 hours lk)r DVD+R DL
(Double Layer) discs).
(normal
F 0:30_1:00-=_7:30_8:00_ recording) "7
"@" and "OTR" light up, and the remaining
recording time appears in the front panel
display.
When the counter reaches "0:00," the recorder
stops recording and turns off.
To cancel t he Quick Timer
Press • REC repeatedly until the counter appears
in the front panel display. The recorder returns to
normal recording mode.
To stop recording.
Press • STOP twice.
Note that it may take a few seconds l\_r the
recorder
to stop recording.
Checking the disc status while
recording
You can check the recording inR)rmation such as
recording time or disc type.
PressDISPLAY during recording.
The intk)rmation disphty appears.
Press the button repeatedly to change the display
(page 43).
i,
2
• Recording may not start immediately after • RE(: is
pressed.
• You cannot change the recording mode during
recording or recording pause.
• If there is a power failure, the program you are
recording may be erased.
I_e°ntinued
47