Table of Contents
Advertisement
Chapter 2 Playback
1 Turn on the amplifier and select the tape
function.
2 insert a cassette.
|
3 Set DOLBY NR to the same position that was
used when the cassette was recorded.
TC-WR635S
TC-WR535
DOLBYNR
DOLBY NR
ON__ON
8
To play back to the
end of one side only
To play back both
sides continuously*
* After playing back five times, the deck
automatically stops.
5 Press ~<a or B> to start playback.
To play back from the front side, press B> .
To play back from the reverse side, press <i.
The tape direction lights up to show the side you
are listening.
To stop playback, press the @ button.
To stop playback momentarily, press the If button (only on
deck B).
To restart play, press the 18 , << or B button.
To fastwind a tape rightward, press the >> button in stop
mode.
To fastwind a tape leftward, press the <4 button in stop
mode.
Is it necessary to set the tape type being used?
No. The deck has an automatic tape type detection system.
To change to recording mode during playback
Keeping the << or B> button pressed, press the @ button.
The unit immediately switches from playback to recording
without stopping the tape. This is useful when editing
previously recorded material.
When decks A and B are in playback mode
Only playback from deck A will be audible.
What is the Dolby NR system?
The Dolby NR (noise reduction) system reduces tape hiss
noise in low-level, high-frequency signals by boosting the
signals during recording and lowering them during playback.
The Dolby S NR system provides the highest reduction in
tape hiss noise in both low and high frequencies (TC-
WR635S som
Note
The Dolby HX PRO system is effective only during recording,
not during playback.
Advertisement
Table of Contents
