Cleaning the Heads and Tape Path
Clean all surfaces over which the tape travels after every ten
hours of operation to guard against:
— low-quality sound
— a decrease in sound level
— excessive wow, flutter or drop-out
— incomplete erasure
— impairment of recording function
To obtain high-quality recorded sound, cleaning before every
recording is recommended.
1 Press 4 to open the cassette holder. Grasp the front
holder on both sides and gently lift to remove it.
2 With the unit turned off, wipe the heads, the pinch
rollers and the capstans with a cotton swab slightly
moistened with alcohol or a commercially available
cleaning fluid for tape decks.
3 Replace the cassette holder.
TC-WR635S
ee
DAC
Recording/
Playback
head
Erasing
h
Pichi rollers
Do not insert a cassette until the cleaned areas are
completely dry.
| DT =vaer-tepal-ser4ialem talzma(srcloks)
After 20 to 30 hours of use, or when you notice hiss and/or
loss of high frequencies, the residual magnetism built up on
the heads should be removed.
1 Turn off the power.
2 Demagnetize the heads with any commercially
available demagnetizer.
Refer to the instruction manual of the demagnetizer
for detailed instructions.
OnT-r-Tal elem datsmOrcle)iatsyt
Clean the cabinet, panel and controls with a soft cloth slightly
moistened with a mild detergent solution.
Do not use any type of abrasive pad, scouring powder or
solvents such as alcohol or benzine.