Table of Contents
Advertisement
Chapter 3 Recording
Follow this procedure to record a source on a cassette (deck
B only).
1 Insert a cassette into deck B.
Wind the tape to the desired starting position
if neccessary.
Deck B
a
s
2 Perform automatic calibration, if desired (see
page 15).
if not, go to step 3.
3 Set DOLBY NR.
TC-WR635S
To record on one side
To record on both sides
Note
Even at the = position, recording automatically
stops when the tape reaches the end of reverse
side.
12
5 Press @ to enter the recording pause mode.
Note
The direction indicator for the side opposite the
specified one will flash for three seconds to
indicate that recording is possible on that side
also. If, however, the tab for that side has been
removed to prevent recording, the indicator will
not flash.
If the tab has been removed from either side A or
B, recording is impossible on the side(s).
To record a cassette for recording, cover the
respective slot with tape. See "To Protect a
Recording" on page 74.
6 Play the program source to be recorded.
7 Turn REC LEVEL to adjust the recording level.
See "Adjusting the Recording Level" on page 13.
REC LEVEL
Soimt¢
8 Turn BALANCE to adjust the balance.
9 Restart the program source, if required.
Advertisement
Table of Contents
