Table of Contents
Advertisement
1 0 Start recording.
To record on the front side of the cassette
Press B> once or Il.
To record on the reverse side of the cassette
|When<Jison [Press <lonce or Il.
[When ison |Press—twice. |
Note
Pressing <#@ or B> twice will cause the unit first
to change tape direction and then start recording
in that direction.
|
To stop recording
Press the &@ button.
PNoplervdlatem (al=maicverelcollarem
MeN Ze)
The optimum recording level, which differs according to the
tape type, is indicated on the PEAK LEVEL METER for each
tape type.
Adjust the REC LEVEL control as high as possible without
exceeding the recommended range for the tape type being
used.
PEAK LEVEL METER readings by tape type
Recommended maximum PEAK LEVEL METER readings.
1, Bao 0
-
-10
4
00
+4
+8
mes
for Type | (normal) or
Type Il (CrOz) tape
for Type IV (metal)
tape
Tips on recording level adjustment
Setting the recording level too low will produce a hissing
sound, while setting it too high will produce distortion.
Generally, the optimum recording level for high and low
frequencies is lower than that for middle frequencies.
Therefore, when recording program sources with many high
and low frequencies, you should set the level to a relatively
low position. For even better results, check the recording
results with your own ears.
Recording FM Broadcasts With the Dolby NR
System
When recording FM broadcasts with Dolby NR system, set
the respective DOLBY NR switch to FILTER ON.
The multiplex filter eliminates remnants of the 19 kHz stereo
carrier and 38 kHz subcarrier signals which may impair the
operation of the Dolby NR system. Be sure to set the
respective DOLBY NR switch to FILTER ON when using the
Dolby NR system. During recording with the Dolby NR
system, use this switch only if the tuner is not equipped with
its own multiplex filter or the equipped filter does not function
effectively.
13
Advertisement
Table of Contents
