Table of Contents
Advertisement
o Unscrew the forced door closure system (B) and fix it to the
opposite side of the door (certain models only).
o Remove the door from the bottom
hinge.
o Unscrew the leg holder fixing screws.
o Tilt the appliance backward at a
maximum angle of 35° Unscrew the
leg support screws (C) - left and right,
and remove the leg support cover (D).
Then place it on the opposite side.
Unscrew, remove and then replace
the position of the end switch (E) and
decorative peg (F) (for models with
forced door closing system).
o Unscrew the three screws fixing the bottom hinge and then fix
the bottom hinge on the opposite side.
o To fit the door on the opposite side of the refrigerator proceed
with the above procedure in reverse. For ease of access to the
freezer compartment, you should also reverse the door on this
compartment.
Troubleshooting
IMPORTANT: If your refrigerator appears not to be
operating properly, before contacting the Baumatic
Customer Care Department, please refer to the
checklist below.
My fridge does not appear to be working/there is no
power to my appliance.
o Check that the plug is fully inserted into the power socket.
o Check that there is power to your mains supply (e.g. that there
hasn't been a power cut or that the fuse hasn't blown).
o Check that the thermostat inside the appliance has not been
turned to the off position.
o Check that your mains supply voltage, corresponds to the
voltage stated on the rating plate of your appliance.
My fridge appears to be performing poorly
o Check that the appliance isn't overloaded and that food hasn't
been packed too tightly into it.
27
Advertisement
Table of Contents
