Makita JR3051T Repair Manual page 16

Fig.30
[1]
1R296
1R461
[1]
Fig.31
Fig.32
[2]
5
When removing Lead wires from Switch [1], insert
a thin pin through the hole near Switch lead wire
insertion port.
6
Attach 1R296 to 1R461, then pull out Lead wire
while inserting 1R296 into the hole.
If it is hard to insert 1R296 into the bottom, tap
1R461 with a plastic hammer to pierce the hole.
7
Remove Handle L [2] from Motor housing [1].
[1]
[2]
8
Remove Tapping screws 5x25 [1] (4 pcs), then
[1]
remove Motor housing [3] from Gear housing [2].
[3]
16 / 32
Tips