Section 4: Assembly; Routing Wires - Grizzly T33955 Owner's Manual

SECTION 4: ASSEMBLY

Routing Wires

Before proceeding with the assembly, three wires
must be routed from the volume control poten-
tiometer on the back of the pick guard to their
proper places on the guitar body.
To route wires:
Lay pick guard face down on guitar body.
1.
Push (1) black ground wire through hole
2.
that leads to rear cavity in back of guitar, as
shown in Figure 4. This wire will be soldered
to spring hanger in later step.
Push (1) black wire and (1) yellow wire
3.
through hole leading to output jack cavity
shown in Figure 4. These will be soldered to
output jack in later step.
To Rear
Cavity
Output Jack
Cavity
Figure 4. Wires correctly routed.
Model T33955 T33956 (Mfd. Since 09/23)
Place pick guard on guitar body as shown in
4.
Figure 5, and temporarily secure with mask-
ing tape. Attached pickups should fit into
routed channels.
Apply Masking Tape
to These Areas
Figure 5. Pick guard placed on body.
DO NOT install screws at this time! Final
5.
adjustments will be made after installing
strings.
-9-