INSTALLATION
2
2.9 Mounting
CAUTION!
Please take care to use the proper gasket to prevent damaging the liner of the flowmeter. In
general, the use of spiral wound gaskets is not advised, as it could severely damage the liner of
the flowmeter.
2.9.1 Torques and pressures
Figure 2-18: Tightening of bolts
Tightening of bolts
• Always tighten the bolts uniformly and in diagonally opposite sequence.
• Do not exceed the maximum torque value.
• Step 1: Apply approx. 50% of max. torque given in table.
• Step 2: Apply approx. 80% of max. torque given in table.
• Step 3: Apply 100% of max. torque given in table.
INFORMATION!
Other sizes / pressure ratings on request.
16
www.honeywellprocess.com
VERSAFLOW MAG 4000
34-VF-25-51 iss.4 GLO May 18 US