RIDGID RD80702 Operator's Manual page 12

ASSEMBLY
ATTAChING ThE TRIGGER hANDLE REST
See Figure 5.
 Locate the trigger handle rest (front and back), Torx screw
(1/4-20 x 1.85 in.), screw (#8 x 3/4 in.), washer (1/4 in.),
and lock nut.
 Push the screws into the holes. Tighten securely using
the lock nut.
RAISING AND LOwERING ThE hANDLE
See Figure 6.
 To raise the handle: pull the handle up until the handle
knob snaps through the locking hole to secure the handle
in place.
 To lower the handle: pull the handle knob out then lower
the handle to the position shown in figure 6.
CAUTION:
Failure to remove pump oil plug label may result in
decreased pump life.
REMOVE ThE LABEL AND ShIPPING PLUG
See Figure 6.
Remove pump oil cap label and shipping plug from the oil
pump.
wARNING:
Make sure the nozzle and hose connections are
secure before starting the machine. A non-secured
accessory could become a projectile if not properly
installed which could result in serious injury.
ASSEMBLING ThE TRIGGER hANDLE
See Figure 7.
 Place the threaded end of the spray wand in the connec-
tor on the end of the trigger handle.
 Turn the connector clockwise until it stops. This secures
the wand in place.
 When not in use, remove the spray wand from the trigger
handle by turning the connector counterclockwise. Store
the unassembled spray wand in the spray wand storage
area.
ATTAChING ThE AUXILIARY hANDLE
See Figure 7.
 Place the threaded stud on the end of the auxiliary handle
into the hole in the trigger handle as shown. Turn clock-
wise to tighten.
NOTE: You can install the handle on either the left or right
side of the spray wand, depending on operator prefer-
ence. The handle must always be used to prevent loss
of control and possible serious injury.
 To switch sides, loosen the auxiliary handle and rotate to
the opposite side. Tighten securely before use.
CONNECTING hIGh PRESSURE hOSE TO
TRIGGER hANDLE
See Figure 8.
 Pull back and hold the collar on the high pressure hose.
Insert the inlet coupler on the trigger handle into the collar.
 Release the collar and push until it locks into place. Pull
on the hose to be certain it is properly secured.
ATTAChING INJECTION hOSE
See Figure 9.
Before detergent can be used with this machine, the injection
hose must be attached.
 Push the open end of the clear injection hose securely
over the fitting as shown in figure 9.
 Place the filtered end of the injection hose in the bottle
of detergent.
CONNECTING ThE GARDEN hOSE TO ThE
PRESSURE wAShER
See Figure 10.
CAUTION:
Always observe all local regulations when
connnecting hoses to the water main. Some areas
have restrictions against connecting directly to
public drinking water supply to prevent the feed-
back of chemicals into the drinking water supply.
Direct connection through a receiver tank or back-
flow preventer is usually permitted.
8 - English