14. Connect each power cord to the server.
15. Connect each power cord to the power source.
16. Power up the server.
The installation is complete.
Installing a rear serial port interface
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
Procedure
1.
Power down the server.
Remove all power:
2.
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
Do one of the following:
3.
•
Extend the server from the rack.
•
Remove the server from the rack.
4.
Remove the access panel.
Remove the serial port blank.
5.
Install the serial port interface.
6.
Installing a rear serial port interface
73