AEG BP5303071 User Manual page 27

1
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
Valid for telescopic runners:
The retaining pins on the tele-
scopic runners must point to the
front.
10.3 Lamp
WARNING!
There is a risk of electrical shock.
The lamp and the lamp glass
cover can be hot.
Before you change the lamp:
• Deactivate the appliance.
10.4 Cleaning the oven door
Removing the door and the glass panels
You can remove the oven door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
Be careful when you remove the
door from the appliance. The
door is heavy.
A
2
A
2. Pull the rear end of the shelf sup-
port away from the side wall and re-
move it.
• Remove the fuses from the fuse box or
deactivate the circuit breaker.
CAUTION!
Put a cloth on the bottom of the
interior of the appliance. It pre-
vents damage to the lamp glass
cover and the cavity.
Always use the same lamp type.
Replacing the lamp at the cavity
ceiling:
1. Turn the lamp glass cover counter-
clockwise to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
1. Open the door fully.
2. Fully press the clamping levers (A)
on the two door hinges.
3. Close the oven door to the first
opening position (approximately 70°
angle).
4.
Hold the door with one hand on
each side and pull it away from the
appliance at an up angle.
ENGLISH
27